Henan Vic Machinery Co.,Ltd

Application:

This rods type oil press is a new type oil press comparing to ring type oil press, its capacity bigger than ring type oil press with high oil output rate, and save labor and power, the final oil is much better than ring type oil press, its especially used to press peanut with hull and especially good for rice bran pressing, it also can be used to press rapeseeds, sesame, sunflower seeds, etc.

Main data:

Model: 6YL-110T rods-type oil press

Capacity: 200-300kg/h for raw materials

Power: 7.5kw(380v/50hz)

Screw shaft speed: 90-120rpm

Oil residue in cake: less than 7%

Size: 1630x490x1210mm

Weight: 480kg

Rods:

Rods installing drawing:

Installment of screw: 

Mounting pressing screw: Put small end of the central shaft upwards,mount the six screw and then the five, four, three, two, one sequencially (Note:Add several circles of cotton thread or waterproof tape on each side of the shaft from the third screw to jam the space between the shaft hole and central shaft,which may keep the center from oil leak), then tighten them by the lock nut to avoid particles in. The one side close locknut is 8309 bearings and the other is 8309, it should be installed the same as the original. Finally, whole pressing screw will be tightened by round nuts with hexagon nut，and gaps between round nut and bearing side would be set at about 0.3-0.7mm(If adjusting bolt can be swung smoothly by hands, the adjustment is acceptable).

Package:

If you're looking for the rod type oil mill machine 6yl-110t, welcome to buy the quality and cheap rod type oil mill machine 6yl-110t with us. We are one of the professional press machine manufacturers and suppliers in China. We will also offer you the wholesale service at big discount.